Now the question is, when should you use each of them? The dry and wet controls of the SEND effect should be set to 100% wet, since you control the amount of effect you send with the “Send Level Control” in your track. The Output of the effects bus ( the signal that got processed ) mixes directly with the track, which gets sent to the Output Bus or interface output. A copy of the same signal gets sent to an Effect Bus.to the stereo output bus or the interface output.Now let’s take a look at the Send effect signal flow In the tracks “In” and “Out” settings you can choose the Output channel. The output of the inserted effect goes to the stereo output channels of your Audio Interface or to stereo output bus in your DAW.The signal from a track goes into the inserted effect, such as EQ, compression,etc.Here is a visual explanation Let’s take a look at the Insert effect signal flow The SEND effect doesn’t change the signal of the original track, it creates a parallel signal path which then blends with the original dry signal. This processed signal then returns to the output of the recording software, where it mixes with the direct signal of the track. Sends vs InsertsĪn insert slot is typically used for processors that change the whole signal, like EQ, Compression, Limiting, Gates, etc., which will alter the signal of the entire track, whereas send effects, such as Reverb, Delay, and other time-based effects, are typically used to add effects to a signal without affecting the original audio.įor Send effects you usually set them up in Bus, then you select which track´s signal you want to send to this effects bus. You record a track and want to add some effects but have no idea if it should be an “insert” effect or a “send” effect. I’m sure this has happened to all of us once getting into music recording and mixing.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |